Operation - Qlima D 115 Gebrauchsanweisung

man_D115.indd 43
THE CONTROL PANEL
This light indicates that the defrost function has been activated. This is
necessary to prevent excessive formation of ice in the device.
This light indicates that the water container is full. The device switches off
automatically.
ON-/OFF-button
Ventilator-button
Timer button
Adjustment buttons hydrostat

OPERATION

1 Insert the plug in the wall outlet.
2 Ensure that the water container has been positioned correctly. If the
on when you use the device for the first time, remove the water container from the
device and replace it in the correct position.
3 Press the -button to switch the dehumidifier on. The
used to set the desired humidity level. The hydrostat is adjustable from 30% to 80%.
The value increases by 5% each time you press the button. The display indicates the
set humidity (SET HUMIDITY) and also the relative humidity (ROOM HUMIDITY).
The device starts to dehumidify when the relative humidity in the room is higher than the
set value.
The device switches off automatically when the set value is reached, and restarts when the
humidity in the room rises again.
4 Select the ventilator speed by pressing the
(= low) and (= high).
5 The timer function enables you to switch the device off after a certain time. The
operating time can be set between 1 and 12 hours with the
press the button, the running time is extended by 1 hour. This will be shown on the
-light switches
-adjustment buttons are
-button. You can select two settings:
-button. Every time you
4
43
20-04-15 10:20