Placing The Ceramic Lumber Set; Maintenance - WANDERS Solea Gebrauchsanweisung

If the pilot flame has died, you must wait at least five
minutes before repeating the above-mentioned steps.
6. Turn the operating knob to the 'ON' position.
7. Turn the motor knob to the left to ignite the burner.
Then you can set the height of the flames with the
motor knob.
Turn the motor now all the way to the right to extinguish
the fire. The pilot flame will stay lighted. If you turn the
'O I' switch to the 'O' position, the pilot flame will die
as well.

Placing the ceramic lumber set

Your Solea gas fireplace is certified for use with natural
and propane gases. The natural gas version has a lumber
set of 8 logs; the propane version has a set of 7 logs.
Please make sure that you place the logs exactly as
shown in the illustrations. Do not put the logs on the
pilot flame as this will prevent the head burner from
igniting and may result in the accumulation of unburned
gasses in the hearth. If this happens you must extinguish
the pilot flame and wait for 5 minutes before lighting the
stove again. Make sure the glass front is closed properly
when burning the hearth.
Please make sure not to leave any finger marks on the
glass. Finger marks leave stains which burn in the glass
and can not be removed later.
Arranging the log set for natural gas.
Arranging the log set for propane gas.
24
It is prohibited to use extra ceramic (wooden) logs or
other materials with the wooden logs. It will prevent
the hearth from working properly and can damage the
hearth beyond repair. It is strongly recommended that
you replace the ceramic wooden logs only by the same
kind of logs produced by WANDERS.

Maintenance

Small maintenance
You can clean the outside of the hearth with a damp
cloth that doesn't give off fluff. Clean the outside only
when the hearth is cold. If some coffee or something
else is spilt on the hearth when it is burning, turn the
unit off immediately. When the hearth has cooled off
completely, you can remove any stains with a damp
cloth. You can clean the (cold) glass pane with a special
cleansing product for ceramic cooking rings.
Do not use any aggressive cleaning products or abrasives
and do not use stove polish.
Annual maintenance
Your gas hearth needs to be checked and maintained by
a certified installer at least once a year. He will check
and if necessary clean the following components:
• The air-tightness of the exhaust pipes for gas and
fumes and the supply pipes of combustion air.