General Safety Rules; Workplace - Rothenberger ROWELD Quick-S-Electronic Bedienungsanleitung

General safety rules

WARNING! Read all instructions. Failure
to follow all instructions listed below may
result in electric shock, fire and/or serious
injury. The term "power tool" in all of the
warnings listed below refers to your mains
operated (corded) power tool or battery operated
(cordless) power tool.
SAVE THESE INSTRUCTIONS.
Explanations for utilized symbols
Observe operating manual
Danger of explosion
Danger of fire
Hot surface
The device
- has been designed and tested in accordance with
EN 60335-1 in connection with EN 60332-2-45
- is CE certificated
- has left the plant in perfect condition as far as
safety is concerned
In order to maintain this state, it is necessary to
observe the contents of this safety information
when handling the device (transportation, storage,
installation, commissioning, operation, servicing,
de-commissioning) as well as the rating plates,
labelling and safety information attached to the
device, otherwise it could endanger persons and
damage the device itself as well as other
equipment.
This safety information applies in the Federal
Republic of Germany. The relevant national rules
and regulations must be observed when it is used
in other states/countries. The generally valid safety
and accident prevention regulations must be
observed in addition to the references in this
Manual.
If the information in this safety information does
not suffice, then you can contact the manufacturer
at any time at the indicated address.
Please check the packaging and file a complaint
with the forwarding agent immediately in the case
of any damages.
Please examine the device prior to commissioning
to ensure that the device has no damages of any
kind. In the event of doubt, please ask a qualified
6
electrician for advice or contact the address shown
below.
If you assume that a danger-free operation
is no longer possible, then take the devic
out of operation and secure it from being
restarted unintentionally
One must assume that a danger-free operation is
no longer possible,
- if the device or the connection lead shows visible
damages
- if the device no longer functions
- if it was stored under detrimental conditions
- after severe demands due to transportation

Workplace

Keep your working area clean and tidy. Disorderly
and non-illuminated working areas can result in
accidents.
Keep children and other people away from the
electrical tools while in use. You can lose control of
the device if you are distracted.
Use the device only for its intended use (see below)
Do not reach into the flow of hot air.
Touching the jet or the protective pipe can
result in burns when it is hot!
A fire can develop if the unit is not
handled carefully!
Caution when using the device near flammable
materials. Do not direct towards one and the same
point for an extended period of time.
Heat can be conveyed to flammable materials,
which are covered.
Never work with the device in
surroundings that could be explosive, or in
which flamable liquids, gases or dust can
be found.
Electrical tools generate sparks, which can ignite
the dust or the fumes
The connection lead may not come into
contact with hot parts
Place on the stand and allow to cool off after use,
before it is packed away.
Toxic fumes can develop when processing
lacquers/paints and plastics. Avoid inhaling the
fumes. Ensure the working area is well ventilated.
Do not leave the device unsupervised, as long as it
is in operation.
ENGLISH