Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL GE-CM 36/47 S HW Li Originalbetriebsanleitung

Akku-rasenmäher
Vorschau ausblenden Andere Handbücher für GE-CM 36/47 S HW Li:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
that you mow it with the highest cutting height
setting fi rst.
Important!
The cutting height setting has an infl uence on the
maximum area that can be mown.
Keep the underside of the mower housing clean
and remove grass build-up. Deposits not only
make it more diffi cult to start the mower; they
decrease the quality of the cut and make it harder
for the equipment to bag the grass.
Always mow along inclines (not up and down).
You can prevent the lawn mower from slipping
down by holding a position at an angle upwards.
Select the cutting height according to the length
of the grass. Make several passes so that no
more than 4cm of grass are cut at one time.
Switch off the motor, pull the safety plug (12)
and remove the batteries (16) before doing any
checks on the blade. Keep in mind that the bla-
de continues to rotate for a few seconds after
the motor has been switched off . Never attempt
to manually stop the blade. Regularly check to
see if the blade is securely attached, is in good
condition and is sharp. If the contrary is the case,
sharpen the blade or replace it. In the event that
the blade strikes an object, immediately switch
off the lawn mower and wait for the blade to come
to a complete stop. Then inspect the condition of
the blade and the blade mount. Replace any parts
that are damaged.
As soon as grass clippings start to trail the lawn
mower, it is time to empty the grass basket. Cau-
tion! Before taking off the grass basket, switch off
the motor and wait until the blade has come to a
stop. Pull out the safety plug (12).
To take off the grass basket, use one hand to lift
up the chute fl ap and the other to grab onto the
basket handle. Remove the basket. For safety
reasons, the chute fl ap automatically falls down
after removing the grass basket and closes off the
rear chute opening. If any grass remains in the
opening, it will be easier to restart the engine if
you pull the mower back approximately 1m.
Do not use your hands or feet to remove clippings
in or on the mower housing, but instead use suita-
ble tools such as a brush or a hand broom.
In order to ensure that the majority of grass clip-
pings are picked up, the inside of the grass bas-
Anl_GE_CM_36_47_S_HW_Li_SPK9.indb 30
Anl_GE_CM_36_47_S_HW_Li_SPK9.indb 30
GB
ket must be cleaned after each use.
Reattach the catch bag only when the motor is
switched off , the safety plug has been pulled out
and the blade has stopped.
Lift up the chute fl ap with one hand and, holding
the grass basket by its handle with the other
hand, hang in the basket from the top.
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Pull out the safety plug and remove all the battery
packs (16) before starting any cleaning work (Fig.
17/Item 8, Fig. 28).
7.1 Cleaning
To make it easy to clean, fold down the push
bar and move the equipment into the cleaning
position. (Fig. 17)
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
Do not clean the lawn mower with running
water, particularly with high-pressure water.
We recommend cleaning the equipment im-
mediately each time after use.
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
Ensure that no water can get into the interior
of the equipment.
For best results, clean the lawn mower with
the provided spatula and with a brush or rag.
7.2 Maintenance
Worn out or damaged blades, blade mounts,
and bolts should be replaced as a set by an
authorized professional in order to keep the
equipment in balance.
Ensure that all mounting components (i.e.
screws, bolts, nuts etc.) are always tightened
so that the equipment can be safely operated
at all times.
Check the grass catch assembly frequently
for signs of wear.
Replace excessively worn or damaged parts
immediately.
In order to ensure that you enjoy the equip-
- 30 -
13.12.2018 11:39:57
13.12.2018 11:39:57

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis