Startup And Shutdown; Startup; Shutdown - Sony ODS-series Benutzerhandbuch

Barcode label precautions
• Use only barcode labels that conform to Sony
specifications.
• Do not affix barcode labels in which Cartridge Memory
is embedded.
• Do not reuse labels or affix used labels on top of existing
labels.
• Remove an old label before affixing a new one. When
removing a label, peel slowly with the label
perpendicular to the cartridge case.
• Affix a new label that will not leave behind adhesive
material when removed (i.e., a label that can be cleanly
removed). If adhesive material remains on the cartridge,
gently rub it off with your finger.
• When cleaning the label area, do not use sharp objects,
water, or chemical cleaners.
• Check the state of labels before affixing them. If there
are defects in the printed characters or barcode, the
barcode may not be read properly, resulting in longer
barcode processing times.
• When peeling labels from a label sheet, be careful not to
stretch the label or cause its edges to curl.
• Be sure to affix labels flat on the cartridge without any
wrinkles or air pockets.
• Be sure to affix labels fully to prevent peeling and
curling.

Startup and Shutdown

Note
Always close the I/E station when starting and shutting
down the unit.

Startup

1
Check that the power cord is connected, and then turn
on the main power switch on the rear panel of the unit.
2
Press the on/standby button on the front panel.
When you press the button, the on/standby indicator
lights green.
Initialization will end, and the unit will be ready for
use when the text on the display stops blinking.

Shutdown

1
Press the on/standby button.
2
When the shutdown confirmation message appears on
the display, use the arrow buttons to select [Yes], and
then press the ENTER button.
Another confirmation message appears if there is a
cartridge in any of the drives.
3
Wait until the on/standby indicator changes from
blinking green to lit in red, and then turn off the main
power switch on the rear panel.
Note
Except in an emergency, always shut down the unit before
turning off the main power switch on the rear panel.
49
Startup and Shutdown