Sony ODS-series Benutzerhandbuch Seite 45

For details on adding or replacing power supply units,
consult your local Sony representative.
b Main power switches
Switch the main power supplies on or off. When using the
unit, leave these switches set to on, and use the on/standby
button on the front panel to switch between the operation
and standby modes.
Note
When turning the main power supplies off, always set the
unit to standby mode using the on/standby button on the
front panel of the ODS-L30M before pressing these
switches.
c AC IN connectors
Connect these to power outlets using power cords.
d DRIVE 1 to 4 connectors (ODS control (ADI /
power supply))
Connect to the ODS CONTROL connector on the drive
unit with the same number (DRIVE 1 to 4) using an ODA
control cable (supplied with the drive unit) to supply
power to the drive unit and to enable ADI control.
e Drive unit indicators
Indicate the status of the drive units. From the top, the
three indicators are as follows.
• POWER indicator
Lit green: Power is being supplied.
• LINK indicator
Blinking blue slowly (once per second): FC cable is not
connected.
Lit blue: FC cable is connected.
Blinking blue rapidly (four times per second): FC cable
is connected and a command is being received.
Notes
• This indicator is lit blue when the FC cable is
physically connected correctly. It is lit blue while the
FC cable is connected, even when in states where the
drive unit cannot be controlled from a computer.
• This indicator is lit blue during drive unit initialization
after power is applied, even if an FC cable is not
connected. In this case, the indicator starts blinking
blue slowly after initialization is finished.
• STATUS indicator
Lit green: The drive unit can be replaced (i.e., drive is
offline and drive power is off).
Lit red: An alarm occurred (alarm code other than 00-
000).
Slow blinking green (1-sec. interval): The drive is
initializing.
Rapid blinking green (0.25-sec. interval): Firmware
update in progress.
Off: Normal status.
f ODS CONTROL connector (ADI / power supply)
Connect to the DRIVE connector with the same number as
the drive on the ODS-L60E to supply power to the drive
unit and to enable ADI control.
g FC (Fibre Channel) connectors
Allow you to connect to servers and external storage via a
Fibre Channel switch.
h Drive unit mount slots
Allow you to install up to four optional drive units
(ODS-D77F).
i OUT 1 (unit interconnection) connector
Connect to the IN 1 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
ODS-L100E) using unit interconnection cable 1 (supplied
with the extension unit).
j OUT 2 (unit interconnection) connector
Connect to the IN 2 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
ODS-L100E) using unit interconnection cable 2 (supplied
with the extension unit).
k IN 2 (unit interconnection) connector
Connect to the OUT 2 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
ODS-L100E) using unit interconnection cable 2 (supplied
with the extension unit).
l IN 1 (unit interconnection) connector
Connect to the OUT 1 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
ODS-L100E) using unit interconnection cable 1 (supplied
with the extension unit).
45
Name and Function of Parts