Startup And Shutdown; Startup; Shutdown; Importing And Exporting Cartridges - Sony ODS-series Handbuch

Startup and Shutdown

Note
Always close the I/E station when starting and shutting
down the unit.

Startup

1
Check that the power cord is connected, and then turn
on the main power switch on the rear panel of the unit.
2
Press the on/standby button on the front panel.
When you press the button, the on/standby indicator
lights green.
Initialization will end, and the unit will be ready for
use when the text on the display stops blinking.

Shutdown

1
Press the on/standby button.
2
When the shutdown confirmation message appears on
the display, use the arrow buttons to select [Yes], and
then press the ENTER button.
Another confirmation message appears if there is a
cartridge in any of the drives.
3
Wait until the on/standby indicator changes from
blinking green to lit in red, and then turn off the main
power switch on the rear panel.
Note
Except in an emergency, always shut down the unit before
turning off the main power switch on the rear panel.
54
Startup and Shutdown / Importing and Exporting Cartridges
Importing and Exporting
Cartridges

Opening the I/E Station

Press the I/E STATION button on the front panel to release
the I/E station lock before opening the I/E station. When
you press the I/E STATION button, the lock releases and
the I/E STATION indicator blinks orange.
Notes
• Press and hold the I/E STATION button (for about one
second) and wait until the I/E STATION indicator blinks
orange before opening the I/E station.
• If the I/E station does not unlock when the I/E STATION
button is pressed, push the I/E station all the way into the
unit and then press the I/E STATION button again.

Importing and Exporting a Cartridge

Insert a cartridge into a slot, and push the cartridge all the
way in until it stops.
Label attachment area facing forward.
When removing a cartridge, pull the cartridge out to the
left while keeping it horizontal.
Closing the I/E station
Slowly push the I/E station all the way into the unit, and
check that the I/E STATION indicator blinks green.
Notes
• If the I/E STATION indicator is blinking orange, the I/E
station is not completely closed.
• A warning tone sounds if the I/E station is left open for
3 minutes or longer.