Messages - Sony ODS-series Benutzerhandbuch

Messages

If there is a problem with the unit's hardware or
configuration settings, the ALARM indicator on the front
panel of the unit flashes red (error) or orange (warning)
and a message appears on the display. Messages are not
displayed during menu operation. Messages are displayed
after pressing the BACK button to exit the menu.
Message Description
ERROR POWER OFF A system reboot is required. Turn the unit off, and then turn it on again.
REQUEST
ERROR An error occurred during booting.
BOOT OS Consult your local Sony representative.
ERROR An error occurred during carrier calibration.
CALIBRATION Consult your local Sony representative.
ERROR A firmware update is required.
FIRMWARE UPDATE Consult your local Sony representative.
REQUEST
ERROR Check that the unit interconnection cable is connected correctly. If there is no problem with the
SERVICE cable connection, maintenance by service personnel is required.
MAINTENANCE Consult your local Sony representative.
REQUEST
ERROR An error was detected during control operations.
Check [Library Status] on the [System] tab of the Library Maintenance Web UI.
WARNING A power supply unit, which is configured for monitoring in the power configuration settings, is
UNIT (1~6) POWER turned off.
(A/B) : OFF Check [Power Configuration Settings] on the [Others] tab of the [Configuration] screen of the
Library Maintenance Web UI. If there is no problem with the settings, consult your local Sony
representative.
WARNING An error was detected in the power supply unit.
UNIT (1~6) POWER Consult your local Sony representative.
(A/B) : NG
WARNING The power supply unit is turned on, but it is not configured for monitoring in the power configuration
UNIT (1~6) POWER settings.
(A/B) : CC Place a check mark in the checkboxes for the power supplies to use in [Power Configuration
Settings] on the [Others] tab of the [Configuration] screen of the Library Maintenance Web UI.
WARNING The unit's internal temperature is too high. The unit will continue to operate, but extended use will
HIGH TEMP cause the unit and drives' internal temperature to increase further, risking failure or even fire.
Consult your local Sony representative.
WARNING The rotation speed of the fan has dropped. The unit will continue to operate, but extended use will
FAN cause the unit and drives' internal temperature to increase further, risking failure or even fire.
Consult your local Sony representative.
WARNING The SSD diagnosis has determined that replacement is necessary.
SSD Consult your local Sony representative.
WARNING Replacement of the lithium battery is necessary.
LITHIUM BATTERY Consult your local Sony representative.
CLOSE The I/E station has been open for 3 minutes. Make sure the I/E station is fully closed.
I/E STATION If the message appears even after closing the I/E station, consult your local Sony representative.
I/E STATION The I/E station button was pressed while the I/E station was locked by an application or the I/E
LOCKED station was configured for use as a storage slot.
Release the lock via the application, and then press the I/E STATION button. If the lock cannot be
released via the application, release the lock using the Library Maintenance Web UI.
I/E STATION The I/E STATION button was pressed while the I/E station was being accessed.
BUSY Wait for the I/E STATION indicator to light green or orange before pressing the I/E STATION button.
If a message appears, refer to the following to resolve the
issue. If the message display persists, consult your local
Sony representative.
57
Messages