Control And Connections - Eneo VKC-1375 Betriebshandbuch

6. Control and Connections

 
UTP- UTP+
(optional) (optional)
1) UTP Connections / Video output (optional)
•  PIN: UTP-
•  PIN: UTP+
2) Day&Night I/O Terminals
To select Day/Night mode using external equipment, connect control lines to the appropriate terminals.
• DAY&NIGHT Output (4 pin)
I t is the function that can turn on external IR LED Lamp by detecting the sensitivity on the AGC level when the
D&N mode is set „AUTO" on the OSD menu of the camera.
4 Day&Night Output
5
COM
• DAY&NIGHT External Input (3 pin)
I t is the function that can be switched to DAY Mode or NIGHT Mode by receiving the D&N on/off signal from
external light sensor or IR LED LAMP. When D&N Mode is set „External" on the OSD menu of the camera.
5
COM
3
Day&Night Input
3) ALARM OUT (6 pin)
Motion detection signals are output through this port. Active state is configurable.
4) Power Input Terminal
100-240VAC Type
12VDC/24VAC Type
3 4
D&N I/O
IN OUT
5V / 0mA: IR LED ON (NIGHT)
0V:
• AC Power Cord
This power cord accepts a 00-40V ~ 50Hz ±Hz
• This terminal accepts a VDC or 4VAC power source from a
VDC or 4VAC ±0%, 50/60Hz ±Hz
• Use certified / listed class  power supply only.
• I t is recommended to use the DC power supply that can support
incrush current over 0.75A.
30
5 6
COM ALARM
GND OUT
IR LED OFF (DAY)
Open contact: DAY
Close contact: NIGHT
7 8
RS-485
485+(RX) 485-(TX)