Auto Exposure; Blc/Wdr; Mask - Eneo VKC-1375 Betriebshandbuch

5.2 Auto Exposure

1) SHT(s) (Electronic Shutter): Select Shutter mode
• Auto (/60 (/50) ~ /00,000 Auto run, Manual 8 step from /60 (/50) ~ /0,000)
2) FLC (Flickerless): Flicker-less On/Off
3) AGC (Auto Gain Control): AGC Gain (Off, Low, Middle, High)
4) Sens-Up (Slow Shutter): Maximum Low-Shutter select. (x-x3 and Off)
5) Offset Add: Force the picture to turn up at low luminance environment

5.3 BLC/WDR

1) Normal AE: BLC/WDR function off
2) WDR (Wide Dynamic Range): Wide dynamic range mode on
3) EHLC (Excessive High Light Compensation): EHLC mode on
• Excessive lighting compensation is performed when the weighting on the high-brightness side is increased.
4) Auto (Auto Weighting BLC): Auto weighting BLC on
5) Spot (User Setting BLC area): Spot metering mode on
• Posi: OSD mode to adjust the position of the spot metering area
• Size: OSD mode to adjust the size of the spot metering area
6) Zone (Preset BLC area): Fixed metering area mode (-9)

5.4 Mask

1) Mask: Select mask area (-5)
2) Func: Select mask function (Privacy, BLM, Both, Off)
• Privacy: Area to screen on the display
• BLM: Back Light Mask
Selected BL Mask area that will be except of the auto exposure
I f there is a high light installed in a limited environment such as an apartment parking garage or gas
station entrance, removing the high light makes it possible to view car license plates efficiently.
• Both: Privacy function and BLM function on
• Off: Function off
3) Edit: Mask area edit
• Edit mode take effect during Func not Off
Size: Adjust the size of the Privacy and BLM mask area
Posi: Adjust the position of the Privacy and BLM mask area
Tilt: adjust tilting of Privacy and BLM mask area
Colour: Select Privacy and BLM mask (0-4)
Transparency: Select Privacy mask transparency (Default 3/0-3)
Mosaic: Select Privacy and BLM mask mosaic On/Off
Adj. Mosaic: Adjust Privacy and BLM mask mosaic level (0-3)
4