Detection - Eneo VKC-1375 Betriebshandbuch

5.5 Detection

• Func: Detection function selection
• Sens Down: Adjust to Motion Sensitivity using left / right buttons (0~55).
1) OFF: Detection function off
2) Zone: Area motion detection mode
• Zone: Select Motion detection zone (Zone-4)
• Func: Select Motion detection on/off
• Size: Press Enter button to adjust the size of the Motion detection area.
• Posi: Press Enter button to adjust the position of the Motion detection area.
• Link Zoom: Select Motion detection with D-PTZ function that On/Off .
When the motion triggered in the area, move to the area with D-PTZ.
3) Motion Trace: Motion trace mode on
• Tracks an object through a scene and generates an alarm.
4) Face Trace: Face Trace mode on
• Tracks face through a scene and generates an alarm.
• Sens Down: lower value is more widen the scope to judge face (0~7)
• Min Size: Minimum face size configuration (0: minimum face size is to none)
NOTE: The result of face trace can be inaccuracy.
5) Mine: Mine area mode
• By this function, User can draw motion detection area with free dotting
• Set Mine: Press the Enter button to Set Mine mode.
< >: Move: Mine Zone move using the Left and Right buttons
UP:Set: Mine Zone setting using the Up button
DN:Clr: Mine Zone clear using the Down buttons.
ENT:End: Press the Enter button to set Mine mode end.
• Clr All: Press the Enter button to set Mine area clear.
• Display: Select Mine Display On/Off
6) Absent: Press the Enter button to Absent detection mode.
• Absent: Detect object appeared or removed the scene
• Sens Down: Adjust sensitivity of Absent check (0-55)
NOTE: In low luminance environment, the accuracy is down of the result.
Because object colour is effect to auto exposure, the accuracy is down of the result
If the object is too big, the accuracy is down of the result.
7) Cross: Cross counting mode
• Zone: Select Cross Zone using the Left and Right buttons (Zone , Zone )
• Size: Adjust the size of the Cross zone
• Posi: Adjust the position of the Cross zone
• Direction: Select Cross Direction
• Alarm Cnt: Set alarm out cross count. Alarm count number is delaying number before output alarm.
• Reset Cnt: Cross count reset
5