4-4. Assembling the input connector
1. Insert the cap onto the end of a cut cable, and then insert
the coil spring onto the cable end.
2. Cut off the coating at 18 mm from the end of the cut
cable.
3. Separate the shielded wires (braided wire), and then twist
them together.
4. Cut off the coating at 2 mm from the ends of the interior
lead wires.
Cable
Cap
Cable
18 mm ± ± ± ± ± 1 mm
Braided wire
Coil spring
2 mm ± ± ± ± ± 0.5 mm
(E) 33