Setting The Drive Speed; Setting The Welding Temperature - Leister VARIANT T1 Bedienungsanleitung

1. Work Mode

1.3 Setting the drive speed

• The drive speed can be adapted with the Drive
the e-Drive
can be carried out with the drive switched on or switched off. If no entry is made by
the controls (4) within 3 seconds, the new drive speed will be accepted.
The Setpoint Value display or Cool Down menu appears on the display (5) (Fig. 9).
• If the welding nozzle (9) is not in the welding position, the (Start)
appear at the bottom left of the display (5).
• The drive can be switched on by pressing the e-Drive , after which the
(Stop)
e-Drive .
• Pressing the e-Drive
display or Cool Down menu appears on the display.
• If the Drive
Length Measurement, Blower and Drive Counter).
• You can change to the relevant menu by pressing the Heating

1.4 Setting the welding temperature

• The welding temperature can be changed with the Heating
temperature can be set in 10°C increments from 100°C to 620°C by turning the
e-Drive . The setting is accepted after 3 seconds, as long as no button is pressed
within these 3 seconds (Fig. 10).
• If this menu is called up from the Setpoint Value display, the heating and blower
can be started by pressing the e-Drive
Cool Down menu can be selected (Section 1.8 Cooling) (Fig. 11).
• If the Heating
the drive speed. This call-up is only possible from the Work display (Section 1.2).
(Only possible with VARIANT T1 230 V~).
• You can change to the relevant menu by pressing the Drive
in 0.1 m/min. increments from 1.5 m/min. to 18.0 m/min. This setting
symbol will appear. The drive speed can be adjusted directly by turning the
again executes the Stop command, which switches off the drive. The Setpoint Value
button is pressed for 3 seconds, the display will change to another menu (see Section 1.6
button is pressed for 3 seconds, the mains voltage will appear below
button. This can be set by turning
or Blower
button. The welding
. Once the heating is switched on, the
or Blower
6.0
620
symbol will
(Fig. 9)
button.
6.0
620
100
(Fig. 10)
6.0
button.
520
80
Profile
(Fig. 11)
%
%
29