Setting The Drive Speed And The Roller Compensation - Leister Costa Bedienungsanleitung

1. Work mode

1.3 Setting the drive speed and the roller compensation

• Pressing the Drive button
sation of the pressure rollers (9 / 10). The inverse parameter is changed. You can
toggle between the two parameters by pressing the Drive button
• If the speed is displayed inverse, this can be set in 0.1m / minute increments from
2.0 m/minute to 12.0 m/minute by turning the e-Drive
refers to both pressure rollers (9 / 10).
• If the roller compensation bar
can be compensated. This position typically means that the lower pressure roller (10)
rotates at the predefined speed value (1 cm / minute) of the welding speed cur-
rently set, which is 5 times faster than the welding speed of the upper pressure
roller (9). These two settings can be performed with the drives switched on or off.
• If the welding nozzle is not in the welding position, the task symbol
appear. The pressure rollers (9 / 10) are closed by pressing the e-Drive
the case, the taskbar symbol
the pressure rollers (9 / 10) will be switched on and the task symbol
be displayed. The speed and roller compensation of the pressure rollers (9 / 10) can
be changed as described above. If the e-Drive is activated when the drives are
switched on, the pressure rollers (9 / 10) will be switched off opened. If no button is
pressed and the e-Drive is not turned within 6 seconds, the display will change back
to the previously set menu (Setpoint Value Display, Work Display or Cooling). If the
Drive button
Measurement, Service, Blower and Drive Counter» (section 1.6).
• You can change from this menu to the pressure rollers (9 / 10) «Setting the Air
Temperature» menu (section 1.4) by pressing the «Heating»
«Setting the Blower Power» menu (section 1.5) by pressing the «Blower»
40
allows you to set the welding speed and roller compen-
will appear. If you press the e-Drive
is pressed for 3 seconds, the display will change to the menu «Length
. The welding speed
is selected, the lower pressure roller (10)
5.7
350
again.
85
5.7
350
will
. If this is
85
again,
will
button or to the
button.
%
%