Installation Instructions - Thermalright Macho 120 Rev.A Handbuch

Installation Instructions:

Step 1:
Step 1 : Take out Macho cooler from the paper box.
Remove the 120mm Fan from the cooler by pulling the Fan Clips upwards in order to give room for ease
of installation. And leave the Fan Clips on the Heatsink Body. Do not remove them.Apply Anti-Vibration
Padding to 4 corners on the Heatsink Body.
Step 2:
Step 2 : Backplate Installation
Choose the platform (775/1150/1151/1155/1156/1366) you are in use. Make four M3L10 Screw Pillars
go through the Metal Back Plate and the Mylar film from bottom towards top. And then place the Metal
Back Plate on the table. Put the four Washers (for Intel) around the Screw Pillars.
Step 3:
Step 3 : 775 Back Plate Cap
Note: When installing on a 775 platform, please
first insert the Back Plate Cap into the opening on
the Back plate, make sure you have the Cap facing
downwards. (Only for LGA775 platform, all other
platforms go directly to Step 3.).
3
1366
775
Step 4:
1
Step 4 : Screw Cylinder Installation
Take one M3L10 screw and put one washer for
Intel around the screw pillar. Snap it through
one of holes around CPU socket from bottom
towards top. Cap the screw pillar with the screw
nut included and then tighten up. Now repeat this
installation for the other three screw pillars in a
criss-cross pattern.
1150
1151
1155
1156
4
2
3