Thermalright Macho 120 Rev.A Handbuch Seite 10

Installation Instructions:
Step 1:
Step 1 : Take out Macho cooler from the paper box.
Remove the 120mm Fan from the cooler by pulling the Fan Clips upwards in order to give room for ease
of installation. And leave the Fan Clips on the Heatsink Body. Do not remove them.Apply Anti-Vibration
Padding to 4 corners on the Heatsink Body.
Step 2:
1
Step 2 : Install the four screw pillars.
Take one M3L10 screw and put one washer for Intel around the screw pillar. Snap it through one of
holes around CPU socket from bottom towards top. Cap the screw pillar with the screw nut included and
then tighten up. Now repeat this installation for the other three screw pillars in a criss-cross pattern.
Step 3:
1
Step 3 : Anchoring Mount Installation
Place the Anchoring Mount on the Screw Nuts. Use the four M3L6 screws to fix the Anchoring Mount on
to the Screw Nuts.
7
4
2
3
3
2
4