Thermalright Macho 120 Rev.A Handbuch Seite 14

Verfügbare Sprachen

Installation Instructions:

Step 1:

Step 1 : Take out Macho cooler from the paper box.

Remove the 120mm Fan from the cooler by pulling the Fan Clips upwards in order to give room for ease

of installation. And leave the Fan Clips on the Heatsink Body. Do not remove them.Apply Anti-Vibration

Padding to 4 corners on the Heatsink Body.

Step 2:

Step 2 : Backplate Installation

Choose the platform AMD AM3/AM4 you are in use. Make four M3L10 Screw Pillars go through the

Metal Back Plate and the Mylar film from bottom towards top. And then place the Metal Back Plate on the

table. Put the four Washers (for AMD) around the Screw Pillars.

Step 3:

Step 3 : Back Plate Cap

Note: When installing on an AMD platform, please

first insert the Back Plate Cap into the opening on

the Metal Back plate, make sure you have the Cap

facing downwards.

Step 4:

Step 4 : Screw Cylinder Installation

Take one M3L10 screw and put one washer for

AMD around the screw pillar. Snap it through

one of holes around CPU socket from bottom

towards top. Cap the screw pillar with the screw

nut included and then tighten up. Now repeat this

installation for the other three screw pillars in a

criss-cross pattern.

AM4

AM3