Transport; Storage; Disposal - ATIKA RMC 40-510 Originalbetriebsanleitung

 worn or damaged components and replace them for safety
reasons
Maintenance
Blade replacement
The cutting blades can be moved even
when the power source is switched off.
Wear protective gloves when working with
the blades. Risk of injury!
Worn blades reduce the performance of the device and put
excessive strain on the motor. Therefore check the condition of
the blades before each use. If necessary, have the blades
sharpened by an expert or replace them with new ones.

Secure the cutting blade against twisting with a piece
of wood.

Loosen the fastening nut (19).

Remove both clamping plates (17, 18).
 Remove the cutting blade


When installing the new cutting blade, pay attention to
the mounting direction specified by the holders in the
cutting blade.
 Mount the two clamping plates (17, 18) and screw all parts
together with the fastening nut (19). Tighten the nut firmly.
When working on the lawn mower, be careful not to
pinch fingers between moving cutting blades and
stationary parts of the machine.
Cleaning
Clean the device carefully after each use to ensure

faultless function to be maintained.
Wear protective gloves when working on the
cutting blade. Risk of injury!
 Clean the device immediately after finishing the work.
 Empty and clean the grass catching bag if necessary.
 Clean the underside of the unit and the cutting blade.
 Clean the housing, especially the vent slots, from grass and
dirt stuck to it.
 Remove the dirt with a cloth or brush.
 Do not clean the machine with running water or high-
pressure cleaners.
 Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.

For information on "Maintenance and cleaning" of the
battery and the charger, please refer to the respective
operating instructions.

Transport

Before each transport, switch off the unit,
remove the safety key and remove the
battery (batteries) to prevent unintentional
start-up.
Even when the motor is switched off, the cutting blade can be
damaged during transport, e.g. over hard ground. Therefore,
set the cutting height to the highest position for transport.

For information on Transport of the battery and the
charger, please refer to the respective Operating
Instructions.

Storage

Before each storage, remove the safety
key and remove the batteries to prevent
them from starting unintentionally.
 Allow the motor to cool down before storing the machine.
 Store unused equipment in a dry, locked place out of the
reach of children.
 Before a longer storage observe the following in order to
prolongate the service life of the machine and to guarantee
a smooth running operation:
thoroughly clean the machine
-
-
Treat metal parts after each use against corrosion using
an environmentally friendly biologically degradable
spray oil.

Never use any grease!

To store the device in a space-saving manner, you
can fold up the handlebar. To do this, open the clamping
brackets on the upper handlebar, loosen the hexagon
nut and then unscrew the star knob nuts on the lower
handlebar. Now fold up the handlebar

For information on storage of the battery and the charger,
please refer to the respective operating instructions.

Disposal

Dispose of the lawn mower, battery, charger, accessories
and packaging in an environmentally friendly manner.
For EU countries only.
Electrical devices do not go into the domestic
rubbish.
According to the European Directive 2012/19/EU on
electrical and electronic scrap, electrical devices that
are no longer serviceable must be separately
collected and brought to a facility for an
environmentally compatible recycling.

For information on disposal of the battery and charger,
please refer to the respective operating instructions.
19