Description Of Device / Spare Parts; Assembly - ATIKA RMC 40-510 Originalbetriebsanleitung

 Observe the safety distance given by the handle bar.
 Be especially careful when turning the lawn mower or
pulling it towards you.
 While the motor is running, do not
 lift or carry the device about
 lift the impact guard
 Make sure that the impact guard is closed or the collecting
bag is attached.
Use only original spare parts and accessories parts.
Accidents can arise for the user through the use of
other spare parts. The manufacturer is not liable for
any damage or injury resulting from such action.
Do not carry out repair operations on the machine
other than those described in section "Maintenance
and cleaning" but contact the manufacturer or
authorized customer service centres.

Refer to the respective operating instructions for notes on
the safety of the battery and the charger.

Description of device / spare parts

+ +
Pos. Denomination
Lower handle hoop
1
Upper handle hoop
2
Switch handle
3
Machine knob nut M8
4
Cutting height adjustment
5
Battery compartment
6
Safety knob
7
Impact guard
8
9 Cup holder
10 Grass catching bag
11 Mulch insert
12A Battery AP 40-2000 (2000 mA)
12C Battery AP 40-4000 (4000 mA)
Charging unit ALG 40-1800
13
Cutting blade
14
Safety label
15
Safety key
16
Plastic clamping plate
17
Clamping plate
18
Nut M10 x 1,25
19
Cable bracket (not illustrated)
20
Screw St 4 x 15
21
Running wheel 7'' (Ø 177,8 mm)
22
23 Wheel cover 7''
Running wheel 10'' (Ø 254 mm)
24
25 Wheel cover 10''
Battery compartment cover
26
Front cover with carrying handle
27
Bracket for handlebar, right
28
16
29
30
31
32

To achieve perfect function of the machine, follow the
notes given in these instructions
Cup holder
Handle hoop
Fasten the lower handlebar (1) on both brackets (28 and 29).
Order-no.



365632


Grass catching bag

365623
365610
365624
365625
365501

365503
365500

365611
363606
365622
Mulch insert
365619
365620
365621
365617

365627
365628

365629
365630



Bracket for handlebar, left
Clamping lever
Filling level indicator of collecting bag
Lateral discharge

Assembly

Fasten the cup holder (9) with 4 screws M 4 x 15 on the
upper handlebar (2).
First insert a screw M8 x 15 through the upper hole and
secure it with a nut M 8

The height of the handle can be adjusted at 2
levels; use either position A or B to fasten the lower
handlebar on the brackets.
Fix the handlebar in the desired position with an M 8 x
15 screw as well as a star knob nut M 8.
Now fasten the upper handlebar (2) on the lower
handlebar (1). Use the clamping levers M 8 x 45 and the
star knob nuts M8 (4)
Fasten the cable on the handlebar using the cable
holders
Pull the impact guard (8) up and hold it.
Hook the collecting bag (10) with the hooks into the
holders on the housing (A).
Make sure the discharge opening is clean and does not
contain any deposits.
The mulch insert and the lateral discharge must not be
attached when working with the collecting bag.
Pull the impact guard (8) up and hold it.
Insert the mulch insert. Slide the mulch insert into the
opening until the latch engages audibly.
To remove the mulch insert, first press out the notch,
then you can remove the mulch insert.
The mulch insert must not be attached when working
with the collecting bag.

365612

365626