First Use; Preparing An Espresso; With Ground Coffee - Krups PERFECTO XP4200 Bedienungsanleitung

KR_ESPRESSO_PERFECTO_XP4200_NC00027827-01 06/12/11 16:20 Page9
■ Do not fill your filter holder to the top, use the measuring spoon (1 spoonful for 1 cup, 2 spoonfuls for
2 cups). Remove any excess ground coffee from the edge of the filter holder (fig. 9b).
■ If the appliance is not used for more than 5 days, empty and rinse the water tank.
■ Before removing the tank to fill or empty it, always remember to switch off the appliance.
■ Always ensure that the appliance is placed on a flat, stable, heat-resistant surface.

5. FIRST USE

Rinsing before first use
Before using your coffee machine, clean all of the accessories in water and washing up liquid then dry
them.
■ Fill the tank with cold water and fit it onto the appliance, ensuring that it is fitted correctly (fig. 1c).
■ Switch on the appliance by pressing the ON/OFF button d2
■ The temperature light flashes then remains lit. The appliance is ready for use (fig. 2).
■ Insert the filter holder (without ground coffee) into the appliance: turn it towards the right as far as
possible (fig. 3).
■ Place a container with a volume of over ½ litre under the filter holder. Turn the switch d1 to the "coffee"
position (fig. 4, 5), then press on the two cup position
■ If the water doesn't run off (pump priming), repeat the process from the beginning.
■ Let the water run from the tank. To stop the flow of water, turn the selector d1 to the position
and unplug the appliance.
■ Remove the tank, empty it and rinse it carefully and fit it back onto the appliance (fig. 1b and 7).

6. PREPARING AN ESPRESSO

IMPORTANT!
If the espresso machine is being used for the first time, the appliance must be
cleaned as described in paragraph 5 "FIRST USE".

With ground coffee

The type of ground coffee that you use will determine the strength and taste of your
espresso: the finer your coffee is ground, the stronger the espresso.
■ Before removing the removable tank, place the selector d1 in the
■ Fill the tank with cold water and fit it back onto the appliance (fig. 7).
■ Switch on the appliance by pressing the ON/OFF button d2
■ The LED flashes while the machine is warming up, then remains lit. The appliance is then ready for use.
■ Release the filter holder by pressing the
the measuring spoon, place the ground coffee into the filter holder: one measuring spoon (filled to the
top) per cup for a good espresso (fig. 9a).
■ Remove the excess ground coffee from the edge of the filter holder (fig. 9b).
■ Insert the filter holder into the appliance tightening it by turning it towards the right as far as possible
(fig. 11).
■ Place a cup on the grill of the drip tray under the filter holder (fig. 12).
■ Turn the selector d1 to the position
■ After a few moments, the coffee stars to flow.
■ When the cups are full. Move the selector d1 back to the
■ Remove the cup.
.
, several times if necessary.
.
button lightly and turning it towards the left (fig. 8). Using
(coffee) (fig. 4).
position (fig. 6).
English
position (fig. 6).
(fig. 6)
9