Selecting A Camera; Controlling A Camera With The Pilot/Center - Geutebruck Pilot Bedienungsanleitung

Working with the Pilot
Controlling cameras
For the functions described in this chapter, a pan/tilt camera (for example, from
ARGUS or a Speeddome) must be connected to the system and configured using
GSCSetup.
The pan/tilt cameras are controlled using the TELECONTROL software, which is a
part of GeViSoft and GSCServer. The control functions for pan/tilt cameras can be
run from the Pilot, so you can operate the cameras from the comfort of your desk.
Ideally, the camera is controlled via a connected Pilot/Joy. This is necessary to
move the pan/tilt head of a camera with the joystick.

Selecting a camera

You always remotely control the camera that is switched onto the preselected moni-
tor. The number of the camera is shown on the display of the Pilot/Center.
To remotely control a specific camera, you can either:
‰ Select the desired camera on the preselected monitor
‰ If the camera is already visible on another monitor, select that monitor
Camera 17 is on Monitor 3. If the Monitor 3 is preselected, Camera 17 can be re-
Example
motely controlled.

Controlling a camera with the Pilot/Center

Control of the active camera is performed with the Pilot/Center using the buttons of
the associated function menus.
Go to menu 4. There the following functions are available.
Moving to fixed positions
Moving to the home position
Press Home Position to move the camera to the home position.
Moving to Position 1
Press Position 1 to move the camera to fixed position 1.
Moving to any position number
To move the camera to any position, select the desired position with the keypad and
then press Move to Position Number X.
If you press Move to Position Number X without having first entered a position
number, the home position will be used.
38
V 1.3