Selecting And Enabling Resources; Selecting A Monitor; Selecting A Camera - Geutebruck Pilot Bedienungsanleitung

Working with the Pilot

Selecting and enabling resources

Selecting a monitor

One of the basic tasks of using the Pilot is to select a monitor and to activate a cam-
era on that monitor.
1.
2.
3.
4.
Maximize the viewer
Tip
Using the Maximize Viewer button on Pilot expansion unit you can maximize the
current viewer (as per the GSCView double-click function) and then make it small
again.

Selecting a camera

The next step is to switch a specific camera onto the selected monitor. In general,
there a number of ways for selecting the camera:
Selecting the camera using its number
1.
2.
In the control bar there are additional functions for the selection of the camera. Go to
Menu 1.
Select next/previous camera
In Menu 1 select the next or previous available camera using the Previous Camera
or Next Camera buttons.
The currently selected monitor then skips forward or back one camera.
Select Camera 1
In Menu 1 press Camera 1 to switch the currently selected monitor to Camera 1.
32
To preselect a monitor, first press the Select Monitor button and then enter the
monitor number via the keypad.
Confirm the number entered with the Enter key.
The number of the monitor and activated camera are displayed.
You can change the number of the preselected monitor with the buttons in Menu
1. Open Menu 1.
Press Next Monitor or Previous Monitor to decrease or increase the number
of the monitor by one.
To select a camera, press Enter Camera.
Enter the number of the camera on the keypad and press the Enter key.
The camera with the entered number is brought up on the currently selected
monitor.
V 1.3