Figure 12 Front And Backside Docking Clamps; Figure 13 Mounting The Front Docking Clamp; Figure 14 Mounting The Rear Docking Clamp - Geutebruck Pilot Bedienungsanleitung

Installation and commissioning
Docking the devices with clamps
To connect the devices permanently together you must use the front and backside
docking clamps.

Figure 12 front and backside docking clamps

Put the device as shown in figure 13 on the table and connect the smaller front
clamp into the profile. First put the clamp into the upper profile and then press the
clamp at the bottom side tight.

Figure 13 Mounting the front docking clamp

Now turn the device and place the bigger backside clamp into the profile. Again first
put the clamp into the upper profile and then press the clamp at the bottom side
tight.

Figure 14 Mounting the rear docking clamp

24
V 1.3