Specifying The Network Addresses - Geutebruck Pilot Bedienungsanleitung

Installation and commissioning

Specifying the network addresses

For a connection to the network, enter the necessary information.
‰ The network settings, such as IP adresse, have to be made in administrator
Note
Enter network name and network address under Network in Windows 7 or activate
the DHCP to allocate the Pilot a Network domain controller directly. Therefore we
suggest you to use keyboard and mouse or activate the Windows 7 virtual keyboard
and use the touch display.
Check your Settings in Pilot Setup under General Settings
1.
2.
3.
4.
5.
6.
28
mode directly on Windows interface in System Settings
Start the Pilot user interface.
Press Editor to access the Settings.
Go to General Settings. The Network Settings you entered before in Windows
7 are apparent now. No Settings possible at this point.
Now go to GeViSoft Settings.
There type the name or IP address of the GeViSoft server and enter the user
name and password that you will use to log on to the GeViSoft server. Use the
virtual keyboard (abc) here as well to make the entries.
Enter connecting server in GeViScope rounting alias that is suppose to work
as the mainserver for the whole system. All GSC View Monitor Actions will be
sent to this Alias-GeViScope Server which is sending all actions to relevant
GSCView Stations in the network. This setting should be necessarily done when
V 1.3