Geutebruck Pilot Bedienungsanleitung Seite 103

5. Use the <Function key offset> and the <IOI42 contact offset> to establish which
6.
V 1.3
offsets for functionkeys and digital in- and output of the particular Pilot
(Jog/Center/Joy) in GeViSoft are suppose to operate as virtual in- and output-
contacts. Please take a look on following (example) table which is coincidental
showing the Pilot default settings.
Function key offset =
9000 (default)
Center F1-F8 (0+ID)
Jog F1-F4 (40+ID)
Joy F1-F4 (60+ID)
IOI43 contact offset =
10000 (default)
Center Input 1 - 8
Center Output 1 - 4
The Sabotage inputs switch defines if you would like to observe all digital in-
puts or not. While using Sabotage-oberservation the input level is constantly
thread in and in case of fault (open access) the action Sabotage is sent to Ge-
ViSoft-Server. Apart from that there is only differentiation between switch open
and closed. The particular action will be activated.
GeViSoft virtual input =
Offset + ID
9001 till 9008
9000+40+ID Æ 9041 till 9044
9000+60+ID Æ 9061 till 9064
GeViSoft virtual input or
output = Offset + ID
10000+0+IDÆ10001 till 10008
10000+0+IDÆ10001 till 10004
Working with the Pilot
Neuer offset =
Neuer offset =
43