Marking And Exporting A Video Sequence - Geutebruck Pilot Bedienungsanleitung

4.
5.
Searching in events
6.

Marking and exporting a video sequence

If you have found an image or video sequence that should be saved, you must first
mark the start and end of the sequence. You can do this either on the Pilot/Center or
directly on the Pilot/Jog.
Then connect a USB storage device and start the export, which will be performed by
GeViSoft and GSCView.
Marking and exporting using Center
1.
2.
3.
4.
5.
Marking and exporting on the Jog/Shuttle
If the Pilot/Jog expansion unit is installed, you can conveniently perform the export
from there.
1.
2.
3.
4.
5.
V 1.3
Clicking again resumes the search.
Clicking on forwards search changes the direction of the search.
If the sought after recordings can be associated with a specific event, then you
can take advantage of that.
Using the Show Next Event and Show Previous Event buttons you can jump
between events.
Either continue the motion search from there or search using the video recorder
functions.
Use the video recorder functions to go to the beginning of the sequence to be
stored.
Use the Set Export Marker 1 button to mark the beginning of the video se-
quence.
Go to the end of the sequence to be stored and mark it with the Set Export
Marker 2 button.
Insert the storage device into the USB port of the Pilot/Center.
Press Start Export. The selected sequence is stored on the USB storage de-
vice.
Use the Jog/Shuttle to go to the beginning of the sequence to be stored.
Use the Set Export Marker 1 button to mark the beginning of the video se-
quence.
Go to the end of the sequence to be stored and mark it with the Set Export
Marker 2 button.
Insert the storage device into the USB port of the Pilot/Jog.
Press Start Export. The selected sequence is stored on the USB storage de-
vice.
Working with the Pilot
37