Figure 9: Removing The Side Panel - Geutebruck Pilot Bedienungsanleitung

Installation and commissioning
Connecting the devices with USB cables
To operate the Pilot/Center and all expansion units on the table or installed as sep-
arate units, you must connect the devices with each other via USB cables.
1.
2.
Devices with S-connectors
to use them as a tabletop or installed device. In this case, the GEUTEBRÜCK S
connector can be used.
Caution
The component can be destroyed by electrostatic discharge.
Ensure suitable ESD protection!
Ground yourself with a grounding strap before you remove the S-connector from the
protective packaging and insert it.
1.
Geutebrück recommends operating the devices in the form shown here, as this
Note
makes it possible to also realize a redundant power supply.
ÆSee the chapter Operating devices with redundant power supply on page 22.
22
Connect the expansion units on the right and left with the Pilot/Center. To do so,
insert the USB cable into a USB slot on the back of the Pilot/Center and into a
slot on the back of the expansion unit.
To operate two expansion units side by side, you connect an expansion unit to
the Pilot/Center and then connect the two expansion units together. To do so,
connect a USB cable into a USB slot on the back of both expansion units.
Alternatively, you can also connect the Pilot/Center directly to the expansion units
Remove the side covers – if already mounted – by pushing the side cover on the
side of the device.

Figure 9: Removing the side panel

V 1.3