Figure 10: Insertion Of The S-Board With Side Cap Removed; Figure 11: Connecting The Device With The S-Board - Geutebruck Pilot Bedienungsanleitung

2.
3.
Note
Make sure to use the S-connector correctly. The arrow labeled HOST should always
point in the direction of the host device. The host is the device connected with the
LAN or your PC system or your view station from GEUTEBRÜCK.
If instead, an expansion unit is connected with a separate PC via a USB cable, the
host arrows must always point towards the PC.
By default, the Pilot/Center is used as the host and peripheral devices are connected
on the left and right.
V 1.3
Insert the S-plug into the Pilot/Center (PCI-X connector under the side cover
right or left)

Figure 10: Insertion of the S-board with side cap removed

Put the devices together.

Figure 11: Connecting the device with the S-board

Installation and commissioning
23