Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and commissioning
System requirements/conditions
Checking the conditions
The following requirements must be met for operation of the Pilot:
‰ Existing video surveillance system with a GeViSoft server.
‰ Networking with free network address for the Pilot. This address must be en-
For commissioning a keyboard and a mouse with a USB or PS2 connection is rec-
ommended. The keyboard and mouse are required if you need to make system
settings as an administrator e.g. setting up the network parameters for this particular
Pilot under Windows 7.
Mounting a device
Installation options
Setup and installation of your Pilot can be performed using two different methods:
The pilot will be used as a tabletop device like a keyboard on the table surface.
As tabletop device
1.
The Pilot will be installed in a table surface.
As an installed
1.
device
2.
3.
Pilot/Center with expansion units
You can connect the Pilot/Center with other Pilot expansion units. You can freely
choose the layout, number and order of the expansion units.
When you connect the devices you have two basic options:
‰ You can connect the devices via a standard USB cable, which is plugged into
‰ Plug the devices directly together. The USB connection is established via the
Proceed as follows:
V 1.3
tered in GeViSoft.
In this case, set up the device and connect it.
Make the connections as described below.
To cut out the holes in the table in the correct size, please use the included
template. Refer to the installation instructions on the template.
Remove the side panels and set the Pilot into the hole.
Connect the equipment as described below.
connectors on the back.
included S-connector.
Installation and commissioning
21
Werbung
Kapitel
Inhaltsverzeichnis
