Setting The Pilot User Interface - Geutebruck Pilot Bedienungsanleitung

Working with the Pilot
Configuring the Pilot

Setting the Pilot user interface

To make some of the following settings, you must be logged on as an administrator.
We recommend using an external USB/PS2 mouse and possibly a keyboard.
Proceed as follows:
The Pilot is connected and the system is booted.
1.
+ +
2.
3.
4.
5.
6.
Configuring basic settings
If you have started the Pilot user interface in administrator mode, you can configure
the basic settings.
Using the Editor button, the settings are opened.
1. Go to the Device Settings tab.
2. Turn the sound on or off and adjust the volume. Even when the sound off, the
Sound
3. Specify whether and which audio files are to be played in case of an alarm, an
4. Enter a PIN for the administrator (default PIN is 1234) and one for the user Pilot
Change Administrator and User PIN code
For safety reasons you have to change the administrator- and user-PIN code while
first time commissioning.
Make a note of both PINs and put it to a safety place.
42
Using the key combination Up Arrow + Down Arrow + Enter, open the logout
dialog.
Select Log off and press OK. You will now see the Windows login screen.
Select the user Admin.
Enter the admin password.
Start the Pilot user interface.
Press Editor to access the Settings.
alarm signal is always issued.
information notice and when a button is pressed.
The particular sound for checkup is played by pushing the speaker key.
(default PIN is 1111).
V 1.3