Trouble.shooting; Replacement.parts; Fault.correction - Parkside PNTS 1300 B2 Originalbetriebsanleitung

Technical and visual modifications may be carried out due to further development without
prior notice. All dimensions, information and statements provided in these Operating In-
structions are therefore subject to amendment. Legal claims which are based on the Oper-
ating Instructions can therefore not be recognised.
Trouble shooting
Problem
Device does not
start
Low or lack of
suction
Replacement parts
You can order replacement parts directly via our Service Centre (see page 41). Please
state the appliance type when placing an order.
Item. Description...................................................................................Product.No.
15 Foam filter, pack of 3 .........................................................................30250130
16 Material filter for dry vacuuming ........................................................30250131
17 Paper filter bags, pack of 5 ................................................................30250132
20 Crevice nozzle ...................................................................................72800039
13/14 Vacuum hose ....................................................................................72800218
18 Floor nozzle ........................................................................................72800217
Possible.cause
Mains voltage is not present
Defective on/off switch (
Worn carbon brushes
Defective motor
Hose system (
jets ( 18/19) blocked
Suction pipe ( 12)
assembled incorrectly
Container ( 6) open
Container ( 6) full
Filter ( 15/16/17) full or
clogged
Ball on filter basket (
incorrectly positioned (e.g.
due to jerky movements)

Fault.correction

Check plug socket, cable, line,
plug and fuse, where appropriate,
repair through electrical specialist
3)
Repair through customer service
13/14) or
Remove obstructions and blockages
Assemble suction pipe correctly
Close container
Empty container
Empty, clean or replace filter
24)
Switch off the equipment so the
ball drops then switch on again
GB MT
31