Trouble Shooting; Spare Parts/Accessories; Fault Correction - Parkside PAS 1200 C2 Originalbetriebsanleitung

GB MT

Trouble shooting

Problem Possible cause
Mains voltage is not present
The equipment is not switched on
Device does
not start
Safety stop due to missing or incor-
rectly inserted pleated filter (
Defective on/off switch (
Defective motor
Suction hose (
tube (
Metal container (
Low or lack
Metal container (
of suction
Pleated filter (
Air filter (

Spare Parts/Accessories

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone (see
"Service-Center" Page 40). Please have the order number mentioned below ready.
Position instruction
manual
15
16+17
18
20
13
38
15) or suction
16) blocked
13) is not closed Close the metal container
13) is full
18) is clogged
20) is clogged
www.grizzly-service.eu
Position exploded
drawing
9
10+11
5
2
6+7

Fault correction

Check plug socket, power cord, line,
plug and fuse, where appropriate,
repair through electrical specialist
Switch on the equipment (see
"Switching on/off")
Insert the pleated filter correctly (see
18) "Cleaning/Maintenance")
8)
Repair through customer service
Remove obstructions and blockages
Empty the metal container (see
"Cleaning/Maintenance")
Clean or replace the pleated filter
(see "cleaning/maintenance")
Clean the air filter
(see "Cleaning/Maintenance")
Description
Metal suction hose
Suction tube + Crevice nozzle 91102909
Pleated filter
Air filter
Metal container
Order No.
91102908
91102910
91099238
91102911