Overview; Contents; Assembly - Parkside PNTS 1300 B2 Originalbetriebsanleitung

GB MT.

Overview

Housing
1 Motor housing
2 Carrying handle
3 On / off switch
4 4 attachment ports for accesso-
ries
5 Suction connection
6 Waste container
7 4 feet with castors and accessory
fittings
8 Mains cable
9 Locking clips
10 Blower connection
11a Cable holder on carrying handle
11b Cable holder on dirt container
(see also
Accessories
12 3-part vacuum tube
13 Vacuum hose with
14 Handle component
Filter
15 Foam filter for wet vacuuming
16 Material filter for dry vacuuming
(already mounted)
17 Paper filter bag for vacuuming
fine dust
. Nozzles
18 Floor nozzle with
19 Turnable insert attachment
with brush and rubber lip, for
vacuuming carpets and smooth
surfaces
20 Crevice nozzle

Contents

Unpack the appliance and check that it is
complete:
The appliance is supplied with the motor
head fitted ( 1). To remove the motor
head, open the securing clips (
28
)
9).
1 Motor housing
2 Carrying handle
6 Waste container
7 4 feet with castors and accessory
fittings
12 3-part vacuum tube
13 Vacuum hose
15 Foam filter
16 Material filter (already mounted)
17 Paper filter bag
18 Floor nozzle with
20 Crevice nozzle
6 cross-head screws
Dispose of the packaging material properly.

Assembly

Pull out the mains plug.
This will prevent danger of injury
from electric shock.
1. Attach the carrying handle (2)
firmly using the cross-head
screws supplied.
Ensure.that.the.notches.on.the.
carrying.handle.go.onto.the.
lugs.on.the.motor.head.(1).(see.
small.picture).
2. Attach the feet (7) and secure the
feet with the Philips head screws
supplied.
3. Insert the filter:
- Foam filter for wet vacuuming
( 15).
- Material filter (
vacuuming
- Paper filter bag for fine dust
( 17)
Never.vacuum.without.a.filter!
4. Place the motor housing (1) on
top of the dirt collector (6) and
close it with the clip (9).
The.fastening.clips.must.be.
16) for dry