Appliance Description; Standard Delivery; Accessories; Preparations - STIEBEL ELTRON DHM 3 Bedienung Und Installation

INsTALLATIoN

Appliance description

8. Appliance description
8.1

Standard delivery

The following are delivered with the appliance:
- Sieve inside the cold water inlet
- Special aerator
- Connection hose 3/8, 500 mm long, with gaskets*
- Tee 3/8*
*for the connection as pressure-tested appliance
8.2

Accessories

Special aerator
- for DHM 3 and DHM 4
- for DHM 6 and DHM 7
Note
Fitting the special aerator supplied provides an optimum
water jet.
34 | DHM
Pressure-tested tap
- WSH 10 | WSH 20 Sensor tap for washbasins
Non-pressurised taps
- WSN 10 | WSN 20 Sensor tap for washbasins
- MAZ Twin lever basin tap
- MAE Mono lever basin tap
ZTA 3/4 - central thermostatic valve
Thermostatic valve for central premixing, for example for opera-
ting an instantaneous water heater with a solar thermal system.
9.

Preparations

f Flush the water line thoroughly. f
Water installation
A safety valve is not required.
Taps
f Use suitable taps (see chapter „Appliance description / f
Accessories").
www.stiebel-eltron.com