Test Symbols; Appliance Description; Operation; Description Of The User Interface - STIEBEL ELTRON CNS 100 F Bedienung Und Installation

OPERATION

APPLIANCE DESCRIPTION

Material losses
!
— Never cover the power cable with a carpet or rug.
Route the power cable away from walkways to
prevent anyone tripping over the cable or knock-
ing the appliance over.
— Avoid using an extension cable. If this is unavoid-
able, only use an undamaged extension cable
with a sufficient cable cross-section for the full
appliance output, as well as undamaged plugs or
coupler plugs and adequate protective measures.
— Position the appliance on a solid base. On a soft
base, the appliance can tip over or the air aper-
tures can become blocked.
— Never move or carry the appliance by pulling on
the power cable.
— Never operate the appliance in the immediate
vicinity of a bath tub, a shower or a swimming
pool.
2.3

Test symbols

See type plate.
The type plate is located on the right on the exterior of the ap-
pliance.
3. Appliance description
The appliance is an electric direct heater.
The appliance is suitable for use between seasons and as a booster
heater in smaller rooms, such as hobby and guest rooms.
The air in the appliance is heated by a heating element and ex-
pelled via natural convection through the air outlet grille at the
top. Cool room air flows in through the apertures at the bottom
of the appliance.
After attaching the feet and making the electrical connection using
the mains plug, the appliance is ready for operation.
WWW.STIEBEL-ELTRON.COM
4. Operation
4.1

Description of the user interface

Switch the appliance ON via the switch on the r.h. side of the
»
appliance.
Set the required room temperature via the continuously vari-
»
able temperature selector (for temperatures see specification
chapter).
As soon as the selected room temperature is reached, it is con-
stantly maintained at this selected temperature through periodic
heating (the output of the appliance must correspond at least to
the required heat demand of the room).
If several appliances are installed in a single room, the setting
at the temperature selector on each appliance can be different.
To avoid excessive power consumption when windows are open,
you should stop the appliance while venting.
4.2

Frost protection

Turn the temperature selector as far to the right as possible. In
»
this position, the temperature controller switches heating on
automatically if the room temperature drops below the frost
protection temperature.
CNS F | 15