Face Mask; Nose Mask - Silvercrest SGS 100 A1 Bedienungsanleitung

7.3 Face mask

1. Prepare the face mask as described
(see "Assembly" on page 7).
2. Switch the on/off switch/steam flow
rate controller 7 to 1 or 2. The LED 8
lights up.
3. Figure C: after approx. 2-3 minutes,
steam is generated. Hold your face into
the face mask. Close your eyes and en-
joy the beneficial effect of the steam.
4. Figure E: the steam quantity can also
be set by means of the manual steam
flow rate controller 11. For more steam,
you push the controller into the direction
MAX, for less steam you push the con-
troller into the direction MIN.
NOTE: the deeper you hold your face into
the face mask, the more intensive the effect
of the steam will be. If this becomes too
much for you, take your head a little out of
the face mask.
5. Switch the on/off switch/steam flow
rate controller 7 to 0. The LED 8 extin-
guishes and the device is switched off.
6. Wait for the device to completely cool
down.
7. Pull out the mains plug 10.
8. By a slight turn to the right you release
the face mask 1 and take it off.
9. If necessary, you take off the lid of the
aroma reservoir 3 and dispose of the
content of the aroma reservoir.

7.4 Nose mask

DANGER! Hazard caused by
hot steam!
Figure B: the distance to the water
container is significantly less during use
of the nose mask 2 and the steam effect
is significantly higher. Therefore, the
nose mask 2 may only be used with
stage 1.
1. Prepare the nose mask as described
(see "Assembly" on page 7).
2. Switch the on/off switch/steam flow
rate controller 7 to 1. The LED 8 lights
up.
3. Figure D: after approx. 2-3 minutes,
steam is generated. Hold your nose
into the nose mask 2. Close your eyes
and enjoy the beneficial effect of the
steam.
NOTE: the closer you place your nose to the
nose mask 2, the more intensive the effect of
the steam on the nasal mucosa will be. If this
becomes too much for you, take your nose a
little out of the nose mask 2.
4. Switch the on/off switch/steam flow
rate controller 7 to 0. The LED 8 extin-
guishes and the device is switched off.
5. Wait for the device to completely cool
down.
6. Pull out the mains plug 10.
7. Pull off the nose mask 2 from the aro-
ma reservoir 4.
8. By a slight anticlockwise turn you re-
lease the aroma reservoir 4 and take it
off.
9. If necessary, you take off the lid 3 of
the aroma reservoir 4 and dispose of
the content of the aroma reservoir.
9
GB