Stanley D 210/8/50 Betriebsanleitung Seite 22

6.2 Condensation water
The condensation water must be drained off each
G
day by opening the drain valve (11) (on the floor of
B
the pressure vessel).
Warning!
The condensation water from the pressure ves-
sel will contain residual oil. Dispose of the con-
densation water in an environmentally compat-
ible manner at the appropriate collection point.
6.3 Safety valve (10)
The safety valve has been set for the highest permit-
ted pressure of the pressure vessel. It is prohibited
to adjust the safety valve or remove its seal. Actu-
ate the safety valve from time to time to ensure that
it works when required. Pull the ring with sufficient
force until you can hear the compressed air being
released. Then release the ring again.
6.4 Check the oil level at regular in-
tervals
Place the compressor on a level and straight sur-
face. Unscrew the oil dipstick (Fig. 8/Item 14) by
turning it counter-clockwise and wipe the dipstick.
Re-insert the dipstick into the filler opening as far as
it will go but do not screw it in. Pull out the dipstick,
hold it horizontally and read off the oil level. The oil
level must be between the two marks MAX and MIN
on the oil dipstick (Fig. 8).
Changing the oil: Recommended hydraulic oil: SAE
15W/40 or an alternative of the same quality. It
should be refilled for the first time after 100 hours of
operation. Thereafter the oil should be drained and
refilled after every 300 hours in service.
FUNCTION
Cleaning of intake filter and/or
substitution of filtering element
Change of oil
Tightening of head tension rods
Draining tank condensate
6.5 Changing the oil
Switch off the engine and pull the mains plug out of
the socket. After releasing any air pressure you can
unscrew the oil drainage screw (15) from the com-
pressor pump. To prevent the oil from running out in
an uncontrolled manner, hold a small metal chute
under the opening and collect the oil in a vessel.
If the oil does not drain out completely, we recom-
mend tilting the compressor slightly.
Dispose of the old oil at a drop-off point for old
oil.
When the oil has drained out, re-fit the oil drainage
screw (15). Fill new oil through the oil filler opening
(14) until it comes up to the required level. Then re-
insert the oil dipstick (14).
6.6 Cleaning the intake filter (1)
The intake filter prevents dust and dirt being drawn
in. It is essential to clean this filter after at least eve-
ry 100 hours in service. A clogged intake filter will
decrease the compressor's performance dramati-
cally. Remove the filter from the compressor and
undo the thumb screw on the air filter. You can then
remove the filter from the two halves of the plastic
housing, tap it to remove the dirt, blast it down with
low-pressure compressed air (approx. 3 bar) and re-
insert it. (Fig. 9)
6.7 Storage
Pull the mains plug out of the socket and venti-
late the appliance and all connected pneumatic
tools. Switch off the compressor and make sure
that it is secured in such a way that it cannot be
started up again by any unauthorized person.
MAINTENANCE RESUMPTIVE TABLE
AFTER THE FIRST
100 HOURS
●
At start-up and after the first hour of work
Periodically and at the end of work
22
Warning!
EVERY 100 HOURS
●
EVERY 300
HOURS
●