Opening The Housing; Mounting For Ip 65 - Siemens AR6181-RX Einbau- Und Inbetriebnahmeanleitung

4.3

Opening the housing

4.4

Mounting for IP 65

Gasket 1 (one-sided
self-adhesive)
Siemens Building Technologies
Fire Safety & Security Products
If you attach the top section of the housing to the bottom section, it slots into place.
This means you should proceed as follows when opening the housing:
Unscrew the safety screw (1)
Insert a screwdriver into the two points on the side of the reader housing
between the top and bottom sections of the housing (2).
Remove the top section of the housing from the bottom section.
Fig. 3: Opening the housing
In order to mount the reader, regarding the IP 65 conditions, the following
instructions are to be followed.
Three special gaskets are enclosed in the reader package.
Gasket 2 (one-sided
self-adhesive)
Fig. 4: Three gaskets in the reader package
Usage
Gasket 1: Between reader and mounting surface, with or without distance frame.
Gasket 2: Between housing base and distance frame.
Gasket 3: Gasket for safety screw.
Installation of the Square reader without distance frame
For an installation without distance frame the gasket 1 has to be stuck on the back
of the housing base. The position of the slits in the gasket has to correspond to the
position of the screw holes in the housing.
Gasket 3
Installation
9
04.2005