Siemens AR6181-RX Einbau- Und Inbetriebnahmeanleitung Seite 15

Siemens Building Technologies
Fire Safety & Security Products
CerPass-protocol (RS485)
Miro cards no reaction
CerPass no reaction
Hitag1/2 up to max. 16 digits card information(4bit-BCD coded)
UCI-protocol (RS485)
Miro cards no reaction
CerPass no reaction
Hitag1/2 up to max. 24 digits card information(4bit-BCD coded)
Clock / Data
Miro cards no reaction
CerPass no reaction
Hitag1/2 up to max. 24 digits card information(4bit-BCD coded)
Within this selection only CerPass access cards or CerPass coded cards will be
read. No reaction will be at the reader AR6181-RX if other cards are presented.
DIP 7 DIP 8 Information to be read
on on ID Number, SIPASS (7bit) coded data
Please note:
The ID Number is an SIPASS format (7bit) coded information written by the user
into the read/write area of the Hitag1/2 cards (Write areas in Hitag1 and Hitag2 are
defined for this type of reader(s)).
Please ensure that the number of positions analysed and the format of the
interface connected can be processed.
UCI-protocol (RS485)
Miro cards no reaction
CerPass no reaction
up to max. 12 bytes card information (7bit-ASCII-format)
Clock / Data
Miro cards no reaction
CerPass no reaction
Hitag1 / 2 up to max. 12 bytes card information (7bit-ASCII-format)
transmitted as up to 24 digits of information (digit - half byte)
CerPass ID cards can be read in selections „serial number" and „CerPass" of
card reader AR618x-RX. The transmitted card numbers are thereby not
identical, caused by the special algorithm of the CerPass coding.
The card information of Hitag2 cards can only be read if the password within
Hitag2 card and card reader is identical (use ASCII minimal protocol to change).
Default AR618x-RX: Default password of the Hitag2 transponder.
ID cards type Hitag1/2 personalised in crypto-mode cannot be supported.
Setting up
Card type
Hitag1/Hitag2
15
04.2005