Commands - Siemens AR6181-RX Einbau- Und Inbetriebnahmeanleitung

5.2.6

Commands

Siemens Building Technologies
Fire Safety & Security Products
To read out the actual settings/parameters only send the command without any
parameter to the reader.
"A": UCI-coding
0 UCI, ABA Code (default)
1 UCI, SIPASS-Code, for Serial-Nr., only with UCI reader protocol.
"B": UCI reader protocol structure
If the UCI reader protocol also transmits the serial number, there can be decided to
transmit the tag type after or before the transmission of the serial number of the
card.
0 Serial no, tag type (default)
1 Tag type, Serial no.
("L": Login) Later extension.
"P": Transponder Password
To set the password for Hitag2 cards. Coding is Hex-ASCII
(i.e.: Password = 0x4D 49 4B 52 ⇒ "4" "D" "4" "9" "4" "B" "5" "2")
The password cannot be read out of the reader memory.
The command "B" without any parameter will be responded only with "OK".
("R": card reader Password) Later extension.
"U": LED switch off control tag
LED switch off if transponder is detected in timer ticks (10 msec)
00 LEDs will not be switched off
01 not allowed
02, ... , FF LEDs will be switched off after a transponder is detected.
"T": Tag buzzer time
Buzzer time for detected transponder in timer ticks (10 msec)
00 no beep
02, ... , FF: beep if a transponder was detected.
"V": version
With command "V" information to reader firmware can be read out.
Contents
RD_TYPE
separator
SW_VERSION
separator
DIP_SWITCH
Tab. 3 Tab. 11: Version data
Parameter: 1 characters
Parameter: 1 characters
Parameter: 8 characters
Parameter: 2 characters
Parameter: 2 characters
Parameter: none
Length Example
8 "AR6181MT"
1 ","
4 Version 01.02 = "0102"
1 ","
8 "10010100"
Setting up
17
04.2005