Operation - HANSGROHE Focus E2 Montageanleitung

Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Mount the S - unions and align them.
3. Fasten the mixer with the washers.
Large differences in pressure between the hot and cold
water supply should be balanced.

Operation

The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
31940000/31943000: The flow is changed from bath
to shower function by pulling the knop at the upper side
of the spout. After shutting off the water flow, the mixer
returns automatically to the bath function.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Centre distance:
Connections G 1/2:
Rate of flow 0,3 MPa:
anti-pollution function
Fault
Insufficient water
Mixer stiff
Mixer dripping
Hot water temperature too low
Instantaneous heater didn't work
English
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 80° C
65° C
150 ± 12 mm
cold right - hot left
approx. 17 l/min
Cause
- Shower filter seal dirty
- Non return valve didn't move back
- Cartridge defective,calcified
- Cartridge defective
- Hot water limiter incorrectly set
- Flow limiter in handshower isn't
removed
- Filter are dirty
- Non return valve didn't move back
To adjust the hot water limiter on single lever mixers,
please see page 34.
No adjustment is necessary when using a continuous flow
water heater.
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
Attention!
The non return valves must be checked once a year.
Spare parts (see page 2)
1 handle
1.1 screw cover
2 flange
3 nut
4 nut
5 cartridge cpl.
6 flange
7 S-union
8 aerator cpl..
9 selector assy
10 diverter knob
11 non return valve
12 seal
13 noise reduction
14 nut
15 nut 31963000
16 nut 31943000
17 connecting thread
18 non return valve
Remedy
- Clean filter seal between shower
and hose
- Exchange non return valves
- Kartusche austauschen
- Kartusche austauschen
- Warmwasserbegrenzung einstellen
- Remove flow limiter
- Clean the filter/exchange filter
- Exchange non return valves
98532000
96338000
97406000
97977000
97209000
92730000
94135000
94140000
13914000
97978000
97981000
94074000
95008000
96429000
96157000
95185000
95184000
97220000
97980000