Yamaha TT-R125LW(M) Wartung Und Service Seite 174

TIRE PRESSURE CHECK
NOTE:
Be sure to remove all dirt and mud from
around the locknut and adjuster before
adjustment.
The length of the spring (installed) changes
1.5 mm (0.06 in) per turn of the adjuster.
CAUTION:
Never attempt to turn the adjuster beyond
the maximum or minimum setting.
5. Tighten:
Locknut
6. Install:
Left side cover
EC36Q000
TIRE PRESSURE CHECK
1. Measure:
Tire pressure
Out of specification → Adjust.
Standard tire pressure:
NOTE:
Check the tire while it is cold.
Loose bead stoppers allow the tire to slip off
its position on the rim when the tire pressure
is low.
A tilted tire valve stem indicates that the tire
slips off its position on the rim.
If the tire valve stem is found tilted, the tire is
considered to be slipping off its position. Cor-
rect the tire position.
3 - 23
INSP
ADJ
42 Nm (4.2 m · kg, 30 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
100 kPa (1.00 kg/cm
2
, 15 psi)