Inhaltsverzeichnis
Werbung
FRONT FORK
Installation
1. Install:
Front fork
NOTE:
Temporarily tighten the pinch bolt (lower
bracket).
Do not tighten the pinch bolt (upper bracket)
yet.
2. Tighten:
Cap bolt 1
3. Adjust:
Front fork top end a
Front fork top end (standard) a:
Zero mm (Zero in)
4. Tighten:
Pinch bolt (lower bracket) 1
Pinch bolt (upper bracket) 2
Screw (dust boot) 3
NOTE:
Make sure that the dust boot holes a are
positioned outward.
Tighten the screw (dust boot) until the top of
the dust boot is touching the lower bracket.
5. Install:
Cap 1
5 - 33
CHAS
23 Nm (2.3 m · kg, 17 ft · lb)
60 Nm (6.0 m · kg, 43 ft · lb)
25 Nm (2.5 m · kg, 18 ft · lb)
Werbung
Inhaltsverzeichnis
