Inhaltsverzeichnis
Werbung
REAR BRAKE SHOE INSPECTION/BRAKE FLUID LEVEL
INSPECTION/SPROCKETS INSPECTION
REAR BRAKE SHOE INSPECTION
1. Inspect:
Brake shoe lining wear limit
Brake shoe lining wear limit checking
steps:
Fully push down the brake pedal and hold
it in position.
Then check the brake shoe wear indicator
1 is within the wear limit a.
Outside the limit →
Refer to "REAR WHEEL AND REAR BRAKE"
section in the CHAPTER 5.
BRAKE FLUID LEVEL INSPECTION
1. Place the brake master cylinder so that
its top is in a horizontal position.
2. Inspect:
Brake fluid level
Fluid at lower level → Fill up.
a Lower level
Recommended brake fluid:
DOT #4
WARNING
Use only designated quality brake fluid to
avoid poor brake performance.
Refill with same type and brand of brake
fluid; mixing fluids could result in poor
brake performance.
Be sure that water or other contaminants
do not enter brake master cylinder when
refilling.
Clean up spilled fluid immediately to
avoid erosion of painted surfaces or plas-
tic parts.
SPROCKETS INSPECTION
1. Inspect:
Sprocket teeth a
Excessive wear → Replace.
NOTE:
Replace the drive, driven sprockets and drive
chain as a set.
3 - 19
INSP
ADJ
Replace the brake
shoe.
Werbung
Inhaltsverzeichnis
