General Cautions - Jacuzzi Aquasoul Installationsanweisung

I Check general operation on the tub as shown in the "Use and
Maintenance Manual".
I Also check that all the fittings (rubber sleeves and air line
tubes) and all the plumbing is well sealed.
Specifically, check correct operation of the overflow and that
there is no leakage from the previously fitted pipes and from
the drain. Let water flow from the taps until the water level is
higher than the overflow level.
I EMPTY THE TUB.
COMPLEMENTS
i
I (
23 Take the sanitising liquid bottle, remove the lid from
)
the opening located under the headrest and pour the
contents of the bottle into the opening (detail 1)
lid back (detail 2-3) (refer to the "Use and Maintenance
Instruction Manual").
i
I (
24 ) Position the headrest in the seat on the back of the tub.
I Apply silicone carefully around the entire rim in the resting
point on the wall.

GENERAL CAUTIONS

JACUZZI EUROPE S.p.A. will not be liable if:
the installation is performed by unqualified personnel and/or
personnel not enabled to perform the installation itself;
the rules, regulations and laws in the matter of electric systems in
buildings in force in the country where the device is installed are
disrespected; the installation and maintenance instructions
contained in this manual are disrespected;
unsuitable and/or non-certified material is used for installation;
incorrect operations are performed which reduce the degree of
protection of jets and which modify the electrocution protection
direct or indirect contact or create isolation, current dispersion or
anomalous overheating;
changes are made to components of parts of the device with
respect to supplied conditions, which will devoid the
Screw the manufacturer's liability;
.
the device is repaired by unauthorised personnel or using non-
genuine spare parts made by Jacuzzi Europe S.p.A.
Jacuzzi® whirlpool products are class I, i.e. fixed appliances, and as
such are not included in the range of application of EUROPEAN
DIRECTIVE 2002/95/CE RHOS.
If the appliance is scrapped, the component parts must be disposed
of as special waste.
9