Stadler Form George Gebrauchsanweisung Seite 8

7. The humidification performance depends on the speed of the fan. If
the auto mode is disabled, the speed level may be changed. Select the
speed level 1, 2, 3 or 4 by repeatedly pressing the «Speed» button (9).
8. Press the «Auto» button (11) to activate the auto mode. The LED above
the «Auto» button lights up. In auto mode, the appliance automatically
maintains the desired humidity level. First, set the hygrostat (10) to the
desired humidity (40 / 45 / 50 or 55 %). The auto mode can not be ac-
tivated when the hygrostat (10) is set to continuous operation (5 LEDs
lit). The lower the current humidity, the higher the speed of the fan is set
automatically. The closer the current humidity is to the desired value,
the lower the speed level is selected (e.g. if desired humidity is 45 % and
current humidity is below 34 %, level 3 is selected, from 35-40 % = level
2, from 41-45 % = Level 1). If the speed level is changed manually (button
9 is pressed), the auto mode is disabled.
9. If you feel disturbed by the brightness of the LEDs (for example in the
bedroom), you can reduce the light intensity by pressing the dimmer but-
ton (12):
• Normal mode (default mode)
• Dimmed mode (push once)
• Lights-out mode (push twice)
• By pushing the dimmer button once more, you can go back into nor-
mal mode.
If there is no water in the appliance, the red water level symbol (13)
lights up in all modes. The red light cannot be dimmed.
10. As soon as the «No Water» symbol (13) lights up, the appliance must
be refilled with water. To do this, remove the water tank (5) and fill it
with clean, cold tap water. After replacing the water tank, the appliance
automatically resumes operation after a few seconds.
11. You can use George to disperse fragrances in the room. It must be
emphasised to please use fragrances extremely sparingly because
an excessive dosage can result in malfunctioning of and damages to
the appliance. In order to use fragrances, remove the water tank (5)
and pull the fragrance container (14) out of the appliance. Let the fra-
grance drip directly onto the cotton pad in the fragrance container.
Add a maximum of 1–2 drops of fragrance into the fragrance container.
Tip: In order to change the fragrance, pull the fragrance container out of
the appliance, remove the cotton pad and clean the container with soap.
Now you may insert a new cotton pad (commercially available) and add
drops of the desired fragrance.
12. If you would like to refill the water during operation, you may remove the
water tank and refill it. The appliance will continue to operate using the
water still in the appliance for at least 5 minutes. As long as the water
tank is replaced within this period of time, the appliance can continue its
service without interruption.
13. If the appliance is not used for several days, the water from the water
tank (2) and from the water tank (5) must be emptied beforehand. Fill
the water tank with fresh water before putting it back into operation.
Important information
Humidification with an air washer takes some time. An air washer works
according to the evaporation principle. In this process the air only absorbs
as much water as it needs at the current temperature (self-regulating