Stadler Form George Gebrauchsanweisung Seite 7

• Do not run the power cord over sharp edges and make sure that it does
not get trapped.
• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
Setting up / Operation
1. George has an integrated carrying handle (16). Place your hand at the top
of the circular hole of the water tank (5) to lift the appliance.
2. Place George at the desired position on a flat surface. Connect the
power adapter (3) to the unit (18) and plug the adapter into a suitable
plug socket.
3. First, remove the protective foil from the evaporator discs (8) and the
fixing adhesive from the Silver Cube (15).
4. Remove the water tank (5) by tilting it back in the upper area. Screw off
the water tank lid (6) and fill the water tank with clean, cold tap water.
Then screw the lid back onto the water tank. Place the water tank on the
water tray (2). The water tray now fills slowly with the water from the
water tank. Important: please do not transport George as long as he is
filled with water. The water could spill over.
5. Turn George on by pressing the On/Off switch (4). The «No Water» indi-
cator (13) lights up when there is not enough water in the appliance. If
all LEDs flash slowly, the water tray (2) is not placed correctly in the ap-
pliance. Slide the water tray all the way into the appliance until you hear
a signal sound. The speed level is set to level 2 and the desired humidity
to continuous operation.
6. The desired humidity level can be set by pressing the hygrostat button
(10) (1 LED = 40 %, 2 LEDs = 45 %, 3 LEDs = 50 %, 4 LEDs = 55 %, 5 LEDs
= continuous operation). Info: Once the desired air humidity is reached,
the appliance stops and the hygrostat LEDs blink. If the measured cur-
rent humidity falls below the set value, the appliance starts to humidify
again. If the current humidity is higher than the set value, the fan runs
every 30 minutes for 90 s.