Operating Elements And Connections - Omnitronic HM-1000 MK2 Bedienungsanleitung

Every OMNITRONIC HM-1000 comes with 8 different colour caps so that every frequency can individually be
marked. After making the necessary adjustments simply attach the colour cap to the end of the microphone
body.
All necessary adjustments can easily be carried out via micro buttons. All modes are indicated on the LC-
display.
If the signal strength at the receiver is too high, the microphone gain can be adjusted in 4 steps: 0, -10, -20
and -30 dB.
The metal housing of the HM-1000 is very rugged and could not be destroyed by falling one meter.
Hand-held microphone with PLL multifrequency transmitter
• Dynamic hand-held microphone with UHF pilot tone technology (PLL)
• Provides high-quality vocal and voice pickup for stages, discotheques, public speaking, theater etc.
• Matches receiver DR-1000 MK2
• Operation in the low-interference UHF band (740-764 MHz)
• 192 carrier frequencies switchable in 125 kHz steps (40 frequencies per MHz)
• Operation range 100 meters
• Multichannel operation with up to 16 microphones possible
• LCD for battery status and frequency
• Sensitivity adjustable in 4 steps (0, -10, -20, -30 dB)
• Lock function avoids undesired changes by users, also accidental shutdown
• Aluminum diecast housing
• Operation via 2 x 1.5 V mignon battery (type AA), not included
• Delivery includes microphone case, microphone holder and 8 color rings to distinguish the microphones on
stage

4.2 Operating elements and connections

1 Power switch
2 Safety cover
3 Mute switch
4 Color ring
5 Battery cover
6 Button SET
For calling and exiting the setup menu for the
transmission frequency, the sensitivity and the lock mode.
7 LCD
Indicates the transmission frequency and the battery
capacity.
8 Buttons D and V
For adjusting the radio frequency, the sensitivity and the
lock function in the setup menu.
9 Microphone cartridge
12/15 00053640.DOC, Version 1.0