Connections; Cleaning And Maintenance; Technical Specifications - Omnitronic HS-1100 XLR Bedienungsanleitung

5. CONNECTIONS

6. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

7. TECHNICAL SPECIFICATIONS

Type:
Directivity pattern:
Sensitivity:
Impedance
Frequency response:
Operation voltage:
Current consumption:
Cable-length:
Connection:
Dimensions:
Weight:
Please note: Every information is subject to change without prior notice. 06.10.2005 ©
1) Insert the microphone arm in the left or right suspension on the
wireframe.
2) Place the headset wireframe around the head so that the wireframe is
horizontal across the back of the head and the ends of the wireframe fit
over and in front of the ears.
3) For maximum gain before feedback, position the gooseneck so that
the microphone grille is within 25 mm (1 inch) of the left corner of the
mouth. Do NOT position it directly in front of the mouth.
4) Connect the connection-cable with the pocket transmitter.
5) If breath noise or "pop noise" is audible over the sound system, install
the supplied windscreen.
Uni-directional condenser headset microphone
Cardioid directivity pattern
-55 dB (± 3 dB)
1.5 kOhm (± 30 %)
50 - 18,000 Hz
1.5 V - 10 V
approx. 0.5 mA
approx. 1,2 m
via 3-pole mini-XLR-plug
250 x 120 x 150 mm
10 g
8/14 13056035_V_1_0.DOC