Batteries; Operating Determinations; Approval; Description Of The Device - Omnitronic HM-1000 MK2 Bedienungsanleitung

Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless have it
checked by a qualified service technician before you operate it again. Any damage caused by liquids having
entered the device is not subject to warranty!
For cleaning, only use a soft lint-free and moistened cloth. Make sure not to allow any water to enter and
never use any solvent cleansers.

2.1 Batteries

Batteries are hazardous waste which need to be disposed of appropriately. If the device is to be disposed,
the batteries have to be removed first. Make sure that the poles are correct when inserting the battery. Never
let batteries lying around openly as there is the danger that these can be swallowed by children or domestic
animals. Immediately consult a doctor when batteries are swallowed!
Leaking or damaged batteries can cause irritations when getting into contact with the skin. In this case use
appropriate protective gloves. Make sure that the batteries cannot be short-circuited, thrown into the fire and
be charged. There is a danger of explosion. Never spill any liquids on the device. Should any liquid enter the
device nevertheless, remove the batteries immediately. Please let the device be checked by a qualified
service technician before you operate it again. Any damages caused by liquids having entered the device
are not subject to warranty!

3. OPERATING DETERMINATIONS

The HM-1000 MK2 is a dynamic hand-held microphone with PLL multifrequency transmitter which
serves for wireless transmission of speech and vocals to the multifrequency receiver DR-1000 MK2.
The system operates in the UHF range 740-764 MHz. The frequency range is divided into 192 channels,
which can be selected as desired with a 125 kHz frequency spacing. The system can be expanded to up to
16 wireless transmission sets, which can be operated in parallel without any intermodulation. The
transmission range is approx. 100 m and depends on the local conditions.
The microphone is only allowed to be operated with two 1.5 V mignon batteries (type AA) and was designed
for indoor use only. Never remove the serial barcode from the device as this would make the guarantee void.

3.1 Approval

This wireless microphone system was tested in accordance with the European standards EN 300422-2, EN
301489-01, EN 301489-09 and EN 60065. Consequently, this product adheres to the R&TTE directive of the
European Union and does not need an individual EC type examination of every member state. The notified
1856
body is
11/15 00053640.DOC, Version 1.0